Can stamping parts be used in daily life
1. Commodity stamping parts: For example, stainless ste...
Free To Post, Free To Register By Minghe Sand Casting Org
First, we need to find out the specific reasons, and then take targeted measures based on the specific reasons. For example, if it is found that the surface of the punch or the die is sharply crushed, which leads to serious pull marks on the surface of the stamping part, then it should be repaired in time, such as grinding or polishing. Method to deal with. If the gap between the convex and concave molds is too small or the size is different, which causes the problem of scratches, then the distance between the convex and concave molds should be re-adjusted until it is suitable.
If it is found after investigation that the surface of the die fillet is relatively rough, which results in scratches on the surface of the stamping part, then the die fillet radius should be polished. In addition, if it is due to the presence of dirt on the surface of the die or the surface of the material during stamping, the workpiece is injured. At this time, it is necessary to keep the surface of the convex and concave die clean and clean it before starting work.
In addition, if the hardness of the convex and concave molds is too low, or the surface is stained with metal scraps, it may also cause the stamping parts to appear pull marks. For this situation, we not only need to increase the surface of the convex and concave molds. Hardness also requires frequent inspection of the surface condition of the convex and concave molds during the stamping process, and timely removal of leftover metal scraps.
In the latter case, if the quality of the lubricant used is too poor, this situation will also occur. At this time, we need to select the corresponding lubricant according to the situation. If necessary, we should filter the lubricant first. In use, to prevent impurities from damaging the surface of the stamping parts.
More related app promotion guides: